Phase 03: real CAM UPER codec + ESP32-C5 TX/RX serial link

- Firmware: rewrite obu-firmware TX loop to be serial-driven (no on-chip timer), add promiscuous RX + GeoNetworking/BTP unwrap (gn_unwrap.c), add binary UART framing to the phone (serial_link.c/.h). Drop local cam_encode() - CAM is now built on the phone.
- Kotlin: byte-exact UPER CAM encoder/decoder ported from cam.c (BitWriter/BitReader/CamUperCodec), matching SerialFrame codec, real UsbSerialTransport (usb-serial-for-android), CamTransmitLoop (1Hz base rate, event/geofence boost, ESP32-C5-only), wired into CamUseCaseRepository for RX and TripRecordingService for TX.
- Add V2X message retention: persist all CAM (own+remote) to Room while recording, drop otherwise (DB v2 -> v3 migration).
- Add jitpack repo + usb-serial-for-android dependency.

Fixes: UsbSerialTransport now uses SerialInputOutputManager.start()/stop() (this lib version manages its own thread internally) instead of manual Runnable/Thread submission, which didn't compile.

obu-firmware/main/tx_custom.h

@@ -0,0 +1,15 @@
+// Copied from opentrafficmap/its-g5-receiver-firmware_txenabled, main/tx_custom.h.
+// See tx_custom.c for what this does and why we pulled it in.
+#pragma once
+
+#include "esp_wifi.h"
+
+#ifdef __cplusplus
+extern "C" {
+#endif
+
+esp_err_t esp_wifi_80211_tx_custom(wifi_interface_t ifx, const void *buffer, int32_t len, bool en_sys_seq, wifi_tx_rate_config_t *tx_rate_config, wifi_band_t band, wifi_bandwidth_t bw);
+
+#ifdef __cplusplus
+}
+#endif