Fix UPER encoding of CurvatureCalculationMode; verified on hardware

CurvatureCalculationMode is the one extensible ENUMERATED in CAM:
  ENUMERATED {yawRateUsed(0), yawRateNotUsed(1), unavailable(2), ...}
UPER encodes an extensible ENUMERATED as an extension bit followed by the root
index - 1 + 2 = 3 bits. All three of our encoders wrote only the 2-bit index,
shifting yawRate and the entire low-frequency container one bit early for any
standards-compliant receiver.

It went unnoticed because every end of this project shared the mistake: the
Kotlin codec was ported bit-for-bit from cam.c, so phone and ESP32 agreed
perfectly with each other and with nothing else. Confirmed against the ETSI
ASN.1 in the C-ITS-Parser checkout, where rasn marks this type - and only this
type - #[non_exhaustive].

Fixed in all three copies of the encoder (app CamUperCodec.kt,
obu-firmware/main/cam.c, obu-cam-transmistter/main/cam.c) plus the decoder,
which now rejects rather than misreads a set extension bit. Frame size is
unchanged at 43 bytes. Transmitter reflashed and the phone decodes its CAMs.

Also in this change:

- serial_link: skip send_frame entirely when no USB host is attached, and raise
  the tx mutex timeout above the worst-case hold. With the phone unplugged every
  write blocked its full timeout while holding the lock, so forwarded CAM_RX
  traffic starved the 1 Hz heartbeat - observed as "tx mutex timeout, dropping
  frame" on the console, and it would have tripped the phone's link watchdog.
  Verified gone on hardware.
- Log decoded and failed CAMs in CamUseCaseRepository. "The app shows nothing"
  had two indistinguishable causes; a silent `?: return` made this bug much
  harder to find than it needed to be.
- Remove the ESP32 send-only/send-and-receive toggle. Reception can't be
  disabled in firmware (raw TX only works while promiscuous), so it was an
  app-side filter pretending to be a radio control.
- V2X monitor follows the serial link state on the ESP32 path instead of MQTT,
  which is permanently disconnected there; CAM intake is gated on the link being
  up, and engine state is cleared when it drops.
- About screen: 0.5.0, Phase 03.
- Track obu-cam-transmistter, the bench CAM transmitter. Its cam.c is compiled
  (unlike obu-firmware's reference copy) and must stay bit-identical to the other
  two - this commit is what that coupling costs when it's broken.
- Document the two-toolchain split: this project builds on IDF 5.5.4, obu-firmware
  on the pinned 6.1. Exporting both in one shell fails confusingly.

Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>

obu-cam-transmistter/main/CMakeLists.txt

@@ -0,0 +1,8 @@
+# wifi_patches.c is intentionally NOT in this list anymore - superseded by
+# tx_custom.c (see that file for why). Left on disk, unused, for history.
+idf_component_register(
+    SRCS "main.c" "denm.c" "cam.c" "geonet.c" "dot11p.c" "tx_custom.c"
+    INCLUDE_DIRS "."
+    REQUIRES esp_event esp_netif nvs_flash driver esp_phy
+    PRIV_REQUIRES esp_wifi
+)