Ashin WalpolaandClaude Opus 5
528637dab6
CurvatureCalculationMode is the one extensible ENUMERATED in CAM:
ENUMERATED {yawRateUsed(0), yawRateNotUsed(1), unavailable(2), ...}
UPER encodes an extensible ENUMERATED as an extension bit followed by the root
index - 1 + 2 = 3 bits. All three of our encoders wrote only the 2-bit index,
shifting yawRate and the entire low-frequency container one bit early for any
standards-compliant receiver.
It went unnoticed because every end of this project shared the mistake: the
Kotlin codec was ported bit-for-bit from cam.c, so phone and ESP32 agreed
perfectly with each other and with nothing else. Confirmed against the ETSI
ASN.1 in the C-ITS-Parser checkout, where rasn marks this type - and only this
type - #[non_exhaustive].
Fixed in all three copies of the encoder (app CamUperCodec.kt,
obu-firmware/main/cam.c, obu-cam-transmistter/main/cam.c) plus the decoder,
which now rejects rather than misreads a set extension bit. Frame size is
unchanged at 43 bytes. Transmitter reflashed and the phone decodes its CAMs.
Also in this change:
- serial_link: skip send_frame entirely when no USB host is attached, and raise
the tx mutex timeout above the worst-case hold. With the phone unplugged every
write blocked its full timeout while holding the lock, so forwarded CAM_RX
traffic starved the 1 Hz heartbeat - observed as "tx mutex timeout, dropping
frame" on the console, and it would have tripped the phone's link watchdog.
Verified gone on hardware.
- Log decoded and failed CAMs in CamUseCaseRepository. "The app shows nothing"
had two indistinguishable causes; a silent `?: return` made this bug much
harder to find than it needed to be.
- Remove the ESP32 send-only/send-and-receive toggle. Reception can't be
disabled in firmware (raw TX only works while promiscuous), so it was an
app-side filter pretending to be a radio control.
- V2X monitor follows the serial link state on the ESP32 path instead of MQTT,
which is permanently disconnected there; CAM intake is gated on the link being
up, and engine state is cleared when it drops.
- About screen: 0.5.0, Phase 03.
- Track obu-cam-transmistter, the bench CAM transmitter. Its cam.c is compiled
(unlike obu-firmware's reference copy) and must stay bit-identical to the other
two - this commit is what that coupling costs when it's broken.
- Document the two-toolchain split: this project builds on IDF 5.5.4, obu-firmware
on the pinned 6.1. Exporting both in one shell fails confusingly.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
10 lines
435 B
CMake
10 lines
435 B
CMake
cmake_minimum_required(VERSION 3.16)
|
|
include($ENV{IDF_PATH}/tools/cmake/project.cmake)
|
|
|
|
# No longer need -Wl,-zmuldefs here - that was only for main/wifi_patches.c's
|
|
# symbol-override attempt (which didn't work anyway; see docs/04-transmit-setup.md),
|
|
# and that file is no longer part of the build. Superseded by main/tx_custom.c,
|
|
# which bypasses the gate at a different layer instead of trying to override it.
|
|
|
|
project(obu_firmware)
|