Ashin Walpola
33c4ec5998
- Firmware: rewrite obu-firmware TX loop to be serial-driven (no on-chip timer), add promiscuous RX + GeoNetworking/BTP unwrap (gn_unwrap.c), add binary UART framing to the phone (serial_link.c/.h). Drop local cam_encode() - CAM is now built on the phone. - Kotlin: byte-exact UPER CAM encoder/decoder ported from cam.c (BitWriter/BitReader/CamUperCodec), matching SerialFrame codec, real UsbSerialTransport (usb-serial-for-android), CamTransmitLoop (1Hz base rate, event/geofence boost, ESP32-C5-only), wired into CamUseCaseRepository for RX and TripRecordingService for TX. - Add V2X message retention: persist all CAM (own+remote) to Room while recording, drop otherwise (DB v2 -> v3 migration). - Add jitpack repo + usb-serial-for-android dependency. Fixes: UsbSerialTransport now uses SerialInputOutputManager.start()/stop() (this lib version manages its own thread internally) instead of manual Runnable/Thread submission, which didn't compile.
1.0 KiB
1.0 KiB
OBU transmit firmware - Phase 2 (in progress: HLN-SV DENM beacon)
Started. See docs/04-transmit-setup.md in the project root for build/flash
steps and how to validate this against your own sniffer.
Implements one profile so far: HLN-SV (aftermarket stationary recovery vehicle), causeCode 94 (stationaryVehicle), subCauseCode 0, active while the hazard-light GPIO is grounded. No location/alacarte containers.
main/main.c- entry point, thephy_11p_set/phy_change_channel(5900,...)register hack, GPIO polling, TX loopmain/denm.c/.h- ASN.1 UPER encoding of a minimal DENMmain/geonet.c/.h- GeoNetworking Basic/Common/SHB headers + BTP-Bmain/dot11p.c/.h- 802.11 OCB (QoS Data, broadcast) frame + LLC/SNAP
Known gaps, tracked as TODOs in the source: no real GNSS (lat/long hardcoded 0), no real time source (detectionTime/referenceTime hardcoded 0, decodes as 2004-01-01), fixed (non-rotating) pseudonym MAC, SHB instead of GeoBroadcast (no multi-hop forwarding), unsecured (no IEEE 1609.2 signing).