Ashin Walpola
d2fd222a62
obu-firmware is now a port of the colleague's standalone VRU station (microbu-esp32c5/firmware, kept beside this repository and gitignored): the vanetza-idf C-ITS stack with the TS 103 097 security entity, credentials in NVS, the station-link v1 protocol over the native USB port (frame type 0x10 in the existing 0xAA55 framing) and over a BLE GATT peripheral, and its ITS-G5 radio adapter. The phone still builds CAM and VAM; the board adds GeoNetworking/BTP and signs with the provisioned authorization ticket. The private key never leaves the board. Builds with ESP-IDF 6.0.2 only, which vanetza-idf pins for the radio's private driver ABI. The previous C firmware stays on disk unbuilt; a full-flash backup of the bench board is kept in firmware-backups/ (gitignored). Changed against the colleague's firmware, marked MicrOBU: in the sources: - Reception unchanged for the app. vanetza-idf drops what it cannot verify (unsigned traffic, every RSU), so each captured frame also goes through the previous gn_unwrap.c and reaches the phone as link opcode V2X_RX (0x85), whose body is the old SERIAL_MSG_V2X_RX payload. - Unsigned transmission still possible, with the previous geonet.c header; the phone chooses per message. - Console on UART0 (CH343 port); the native USB port carries only link frames. - BLE advertising pauses while the USB link is in use: BLE and ITS-G5 share one RF front end. - NVS 80 KB (app at 0x20000). At 24 KB, with Wi-Fi settings the previous firmware left behind, the BLE bond could not be stored and the phone had to pair on every connection. - Bench fixes: the radio queue is drained before the first PoTi (no RX and ~177 queue drops before); the station loop waited pdMS_TO_TICKS(5) = 0 ticks at 100 Hz and starved the idle task; the 2.4 KB RX capture buffer is off the Wi-Fi task stack; BLE notifications longer than the MTU are dropped instead of cut short, MTU 517; serial writes are skipped with no USB host. - Manual country policy and TX-power read-back from the previous radio setup; logs for BLE encryption changes and the number of stored bonds. Verified on the bench board (COM3) with the phone over USB and BLE: CAM and VAM, signed and unsigned, go out; reception of the sim car and the RSU's CAM/SPATEM/MAPEM continues; the board survives app restarts and reconnects. See docs/06-signed-its-vam-ble.md.
9 lines
567 B
CSV
9 lines
567 B
CSV
# Name, Type, SubType, Offset, Size, Flags
|
|
# MicrOBU: NVS 80 KB instead of the colleague's 24 KB (their board has 4 MB of flash, this one 16 MB).
|
|
# NVS holds the BLE bond, the credential bundle and PHY calibration; at 24 KB, with Wi-Fi settings the
|
|
# previous firmware had left in it, there was no room for the bond, so the board forgot the phone
|
|
# after every connection. The app therefore moves from 0x10000 to 0x20000 (64 KB aligned).
|
|
nvs, data, nvs, 0x9000, 0x14000,
|
|
phy_init, data, phy, 0x1D000, 0x1000,
|
|
factory, app, factory, 0x20000, 0x300000,
|